Fisher & Paykel 24 Inch Condensing Dryer Install Guide - Manual (Page 14)

12
INSTALLATION INSTRUCTIONS
Electrical connection information for electric dryers
For direct wire connections:
! WARNING!
Fire Hazard
● ●
Use 10 gauge copper wire.
● ●
Use a UL-listed strain relief.
● ●
Disconnect power before making electrical connections.
● ●
Connect neutral wire (white or center wire) to center terminal.
● ●
Ground wire (green or bare wire) must be connected to green
ground connector.
● ●
Connect remaining two supply wires to remaining two terminals.
● ●
Securely tighten all electrical connections.
● ●
Replace the terminal block cover.
● ●
Failure to do so can result in death, fire or electrical shock.
Grounding instructions
For a permanently connected dryer:
This dryer must be connected to a grounded metal, permanent wiring system, or
an equipment-grounding conductor must be run with the circuit conductors and
connected to the equipment-grounding terminal on the appliance.
WARNING!
Improper connection of the equipment-grounding conductor can result in a risk
of electric shock. Check with a qualified electrician, or a Fisher & Paykel trained
and supported service technician if you are in doubt as to whether the appliance
is properly grounded.
SAVE THESE INSTRUCTIONS