Beko 24 Inch Built-In Microwave Installation Instructions - Manual (Page 21)

Turn two full turns on each screw
Cabinet mounting bolt
Washer
The Filler Block is only used for recessed cabinet and
front overhang cabinet (see the type of the cabinet on
pages 8–10). Place the Filler Block to the cabinet bottom
before installing the oven.
5. Tighten the outer two screws to the top of the microwave
oven. While tightening screws, hold the microwave oven
in place against the wall and the top cabinet.
Cabinet front
Equivalent to
depth of cabinet
recess
Cabinet bottom
Filler block
Cabinet mounting bolt
Microwave oven top
Washer
6. Install grease filters. See the Use & Care Manual packed
with the microwave.
C5. CHANGE THE CHARCOAL FILTER
The charcoal filter is used for nonvented, recirculated instal-
lation. The filter should be changed every 6 to 12 months
depending on use.
1. Remove two screws of the louver on the top of the oven
by using a #1 Phillips screwdriver.
Charcoal Filter Louver Louver Screws
2. Open the door, remove the louver and take the used
charcoal filter out.
Charcoal
Filter
3. Install the new charcoal filter. When properly installed,
the wire mesh of the filter should be visible from the front.
4. Replace the louver and the screws.
STEP-BY-STEP INSTALLATION GUIDE
3
21 / 24 EN Over The Range Microwave Oven / Installation Manual