Epson ES-1200C - Manual (Page 13)

Important Safety Instructions
Read all of these instructions and save them for later reference. Follow
all warnings and instructions marked on the scanner.
l
Unplug the scanner before cleaning. Clean with a damp cloth only
and do not use liquid or aerosol cleaners. Do not spill liquid on the
scanner.
l
Do not place the scanner on an unstable surface or near a radiator or
heat register.
l
Do not block or cover the openings in the scanner’s cabinet. Do not
insert objects through the slots.
l
Use only the type of power source indicated on the scanner’s label.
l
Connect all equipment to properly grounded power outlets. Avoid
using outlets on the same circuit as photocopiers or air control
systems that regularly switch on and off.
l
Do not let the scanner’s power cord become damaged or frayed.
l
If you use an extension cord with the scanner, make sure the total
ampere rating of the devices plugged into the extension cord does
not exceed the cord’s ampere rating. Also, make sure the total of all
devices plugged into the wall outlet does not exceed 15 amperes.
l
Except as specifically explained in this User’s Guide, do not attempt
to service the scanner yourself.
l
Unplug the scanner and refer servicing to qualified service personnel
under the following conditions:
If the power cord or plug is damaged; if liquid has entered the
scanner; if the scanner has been dropped or the cabinet damaged;
if the scanner does not operate normally or exhibits a distinct
change in performance. Adjust only those controls that are
covered by the operating instructions.
l
If you plan to use the scanner in Germany, observe the following:
To provide adequate short-circuit protection and over-current
protection for this scanner, the building installation must be
protected by a 16 Amp circuit breaker.
des Scanners an die Netzversorgung
sichergestellt werden, die mit einem
16 A Uberstromschutzschalter abgesichert ist.
4 Introduction