Electrolux 86070 VI - Manual (Page 39)

Operating Instructions
39
After remedying the O , ` or \ error, shut the door.
After rectifying an Å 10 or Å 20 error, press the button for the dish-
washing cycle that has been started. The dishwashing cycle will con-
tinue.
If the fault is displayed again, please contact customer service.
3 For all other errors displayed, please contact customer service, stating
the error code. (See chapter “Customer Service”).
Two short continuously
repeated warning tones can
be heard; the cycle display
for the selected cycle is
flashing; error code
Å 20 is
displayed in the multi-dis-
play.
The siphon is blocked. Clean out siphon.
The water drain hose has
not been correctly laid.
Check hose installation.
Three short continuously
repeated warning tones can
be heard, error code
Å 30 is
displayed in the multi-dis-
play.
The leak prevention system
has been triggered.
Turn off the tap and
contact customer serv-
ice.
One long continuously
repeated warning tone can
be heard; the O indica-
tor is continuously illumi-
nated.
The middle spray arm is
jammed.
Open the door care-
fully. Hot steam may
escape when the door is
opened. There is a risk of
scalding. Arrange the
dishes and cutlery in the
racks so that the spray
arm above can rotate
freely. Close the dish-
washer door.
The
`
indicator is continu-
ously illuminated.
The door of the dishwasher
is open. Close the dishwasher
door.
The
\
indicator is contin-
uously illuminated:
The indicator
\
is only
intended to remind you to
occasionally check the dish-
washer’s filter and to clean
it out when necessary. It
becomes illuminated at reg-
ular intervals, regardless of
the state of cleanliness of
the filter.
The indicator goes out
automatically at the
start of the next dish-
washing cycle.
Malfunction Possible cause Remedy