Electrolux 86070 VI - Manual (Page 36)

Operating Instructions
36
Switching off the dishwasher
When the dishwasher cycle has ended, the dot shaped light signal on
the floor below the door of the appliance goes out.
If the acoustic signal is activated, at the end of the dishwasher cycle a
15 second long continuous acoustic signal is heard.
If the dishwasher door is not opened, the acoustic signal will repeat
after 3 minutes and again after 6 minutes.
1 Hot steam may escape if the door is opened immediately after the end
of the cycle. Therefore:
0 1. Open the door carefully.
2. Switch off the dishwasher using the ON/OFF button.
All display indicators will go out.
3
Removing the dishes
• Hot dishes are sensitive to knocks. Therefore leave the dishes to cool
before removing them.
• Leave the dishes in the dishwasher for approx. another 15 minutes
after the end of the cycle for a better drying result and to allow them
cool down.
• Empty the lower basket first, then the upper basket. This way you
avoid dripping any water remaining in the upper basket onto dishes
in the lower basket and leaving water stains.
Care and Cleaning
1 Do not under any circumstances use furniture care products or aggres-
sive cleaners.
• If necessary, clean the controls only with a soft cloth and pure warm
water.
• Occasionally check the internal containers, door seal, and water inlet
for soiling, clean if necessary.