Electrolux 86070 VI - Manual (Page 38)

Operating Instructions
38
What to do, if ...
Try to rectify minor faults on the dishwasher with the aid of the
instructions given here. If you call an engineer to resolve a of fault
listed here, or to repair a fault caused by incorrect use or installation, a
charge will be made even if the appliance is in guarantee.
...Error messages are displayed.
If your appliance is equipped with an optical floor signal, in the event
of an error a dot-shaped optical signal will flash on the floor.
3 Errors will only be indicated acoustically if the acoustic signal has been
activated.
If, as listed in the table below, any of the indicators in the control panel
or the display panel are flashing or are illuminated, and/or if an acous-
tic signal can be heard, you can probably rectify the fault yourself.
Malfunction Possible cause Remedy
One continuously repeated
warning tone can be heard;
the cycle indicator for the
selected cycle is flashing: The
^
indicator is continuously
illuminated: Error code Å 10
is displayed in the multi-dis-
play: There is no water run-
ning into the dishwasher.
The tap is blocked or furred
with lime-scale.
Clean tap.
The tap is turned off. Turn the tap on.
The filter (where present) in
the threaded hose fitting at
the water inlet valve is
blocked.
Clean the filter in the
threaded hose fitting.
Filters in the base of the
washing compartment are
blocked.
Press the button for the
commenced dishwash-
ing cycle; then abort the
dishwashing cycle (see
chapter: “Starting a
dishwashing cycle”);
Starting a dishwashing
cycle clean out the fil-
ters (see chapter:
“Cleaning the filters”).
The water inlet hose has not
been correctly laid.
Check hose installation.