Enviro EG28-120 - Manual (Page 29)

29
Secondary Installation
I
NSTALLATION OF
L
OG
S
ET AND
E
MBERS
:
The placement of the logs is not
arbitrary. If they are positioned
incorrectly, the flames can be “pinched”
and will not burn correctly. The burner
come with five (5) locator pins and two
(2) resing areas, which make alignment
easier. Using the pictures provided,
carefully set the logs in place.
NOTE: The logs are fragile and
should be handled gently.
CAUTION: Use only the type of ember
material supplied with this appliance.
Due to the irregular size of the ember
material there may be more than
required. The use of other foreign
materials on the burners may create
dangerous conditions.
If over time, through cleaning and
servicing, these embers require
replacement, contact the nearest
ENVIRO dealer for replacement
embers.
1. The embers can be place before
or after the logs are placed. A bag of
ceramic fiber embers and rock wool
embers is provided gently remove the
ember material from the plastic bag.
Spread a layer loosely in a random
manner across the burner tray. Do not
allow any embers to rest against pilot
assembly. (See Figure 13 or 16 for
proper ember placement.)
DO NOT pack this ember material as
this could create an unsafe condition,
leave embers loose
2. Carefully remove logs from box.
Check to ensure there is no damage.
It is very important to install all logs
in their proper position to insure safe,
optimum operating conditions.
Figure 40: Step 1 of Log Placement.
Figure 41: Step 2 of Log Placement.
Figure 42: Step 3 of Log Placement.
Figure 43: Step 4 of Log Placement.