Epson C823301 - Manual (Page 9)

Fax modem mode
If you want to use the fax board to send faxes from your
computer, you need to buy a straight through serial (or
modem) cable and appropriate fax modem software. One
cable is included with your fax board, but you need an
additional cable to connect the board to your computer.
You need a standard straight through (or modem) cable with a
25-pin connector on one end and a 9-pin connector (for the
computer) on the other end or with 25-pin connectors on both
ends, depending on the serial port of your computer. Check
your computer before you buy the cable. When you have the
appropriate serial cable, follow the steps below:
1. Connect the 9-pin connector of the supplied cable to the fax
board.
2. Connect the 25-pin connector of the modem cable to the
25-pin connector of the supplied cable.
3. Connect the 9-pin (or 25-pin) connector of the modem cable
to your computer.
4. Follow the instructions for your fax modem software to
install and use the software.
Where to get help
Epson America provides local customer support and service
through a nationwide network of authorized EPSON dealers
and Service Centers.
EPSON also provides technical assistance with the installation,
configuration, and operation of EPSON products through
EPSON Connection. U.S. users can call (800) 922-8911;
Canadian users can call (800) GO-EPSON.
8 Setup