Electrolux 79902G - Manual (Page 29)

29
Connection
IMPORTANT: This hob must be installed by
a competent person to the relevant Gas
Standards.
Any gas installation must be carried out
by a competent person.
The manufacturer will not accept liability,
should the above instructions or any of
the other safety instructions
incorporated in this book be ignored.
Carry out connection to the gas supply using a
rigid metal pipe with connections conforming
to the rules in force, or with a flexible s/steel
tube conforming to the relevant rules in force,
limited to those whose max. length is 2 m. If
flexible metal tubes are used, make sure they
do not come into contact with mobile parts or
are crushed. Pay the same attention also when
an oven and top combination is provided for.
The appliance gas inlet connection is 1/2"
cylindrical threaded male.
Screw the parts
together without using excessive force.
IMPORTANT: After installation, always
check the perfect tightness of all the
connections, using a soapy solution.
NEVER carry out this check with a
flame.
A) Gas ramp end with nut
B) Washer
C) Elbow