ESPRIT EL355 - Manual (Page 12)

EL355 Elliptical
11
STEP 3: Connecting arm & rear rail assembly
1. Align the hole in the rod end bearings at the ends of the Connecting Arms (7&8) with the hole
in the bracket of the Swing Arms (4&5). There is a sleeve spacer already installed in the rod
ends and held in place with a twist tie; make sure these spacers do not fall out during
assembly. The rod end bearing should be positioned to the inside of the swing arm brackets.
Install two 5/16" Hex Head Bolts (71) through the left and right swing arm brackets and the
rod end and secure with 5/16" Flat Washers (98) and 5/16" Nuts (105).
2. Install the two Rear Rail Tubes (14) to the rear end of the Main Frame (1) and secure with two
3/8” x 2-1/4” Button Head Socket Bolts (76), two 3/8” Flat Washers (94) and two 3/8” Nuts
(89).
3. Install the Rail Stabilizer (13) between the rearward ends of the Rail Tubes (14) and secure
with four 3/8” x 2-1/4” Button Head Socket Bolts (76) and 3/8” Curved Washers (114).