Exmark Vantage VT740EKC604; - Manual (Page 47)

Troubleshooting
Troubleshooting
Important: It is essential that all operator safety mechanisms be connected and in proper operating
condition prior to mower use.
When a problem occurs, do not overlook the simple causes. For example: starting problems could be caused
by an empty fuel tank.
The following table lists some of the common causes of trouble. Do Not attempt to service or replace major
items or any items that call for special timing of adjustments procedures (such as valves, governor, etc.). Have
this work done by your Engine Service Dealer.
Note: When disconnecting electrical connectors Do Not pull on the wires to separate the connectors.
Problem Possible Cause Corrective Action
1. PTO is engaged. 1. Disengage the PTO.
2. One of the speed control levers are not
in neutral position.
2. Ensure the speed control lever is in the
neutral position.
3. Battery does not have a full charge. 3. Charge the battery. See Check
Battery Charge and Recommended
Jump Starting Procedure sections in
Maintenance.
4. Electrical connections are corroded, loose
or faulty.
4. Check the electrical connections for
good contact. Clean connector terminals
thoroughly with electrical contact cleaner,
apply dielectric grease and reconnect.
5. Fuse is blown. 5. Replace the blown fuse.
6. Neutral LCD indicator does not
illuminate.
6. Check reed switch.
Starter does not crank.
7. Relay or switch is defective. 7. Contact an Authorized Service Dealer.
1. Fuel tank is empty. 1. Fill the fuel tank.
2. Fuel shutoff valve is closed. 2. Open the fuel shutoff valve.
3. The throttle and choke are not in the
correct position.
3. Be sure the throttle control is midway
between the “SLOW” and “FAST”
positions, and the choke is in the “ON”
position for a cold engine or the “OFF”
position for a warm engine.
4. Dirt in fuel filter. 4. Replace the fuel filter.
5. Dirt, water, or stale fuel is in the fuel
system.
5. Contact an Authorized Service Dealer.
6. Air cleaner is dirty. 6. Clean or replace the air cleaner element.
7. Electrical connections are corroded, loose
or faulty.
7. Check the electrical connections for
good contact. Clean connector terminals
thoroughly with electrical contact cleaner,
apply dielectric grease and reconnect.
8. Relay or switch is defective. 8. Contact an Authorized Service Dealer.
9. Faulty spark plug. 9. Clean, adjust or replace spark plug.
10. Spark plug wire is not connected. 10. Check the spark plug wire connection.
Engine will not start, starts hard, or fails to
keep running
11. MIL illuminates and blinks 11. Contact an Authorized Service Dealer.
47