Ei Electronics Carbon Monoxide Alarm Ei 205ENA - Manual (Page 15)

5. INSTALLATION
WARNING: Do not use the CO Alarm on an intermittent basis, or as a portable detec-
tor for the spillage of combustion products from fuel burning appliances or chimneys.
5.1 INSTALLATION PROCEDURE
Once you have selected
a suitable location, power
up the unit by smoothly
withdrawing the red
“PULL” tab at the top left
hand corner of the alarm,
(see Figure 5b). The
green, red & amber lights
will immediately flash in
sequence to show they
are working - this is
normal.
Once you have selected a suitable location, open the battery compartment by sliding
up the cover as shown in figure 5a.
(If the batteries are supplied loose then install the batteries ensuring they are
orientated correctly as shown in the battery box. The green, red & amber lights will
immediately flash in sequence to show they are working - this is normal).
15
MOUNTING
HOLES
PRESS HER
FIRST AND
SLIDE UP
GAS
ENTR
HOLE
Figure 5a
B15583/R0/204EN&205EN/U&C 8/6/06 1:54 PM Page 15