Electrolux LAVAMAT 42230 - Manual (Page 36)

36
Electrical connection
Information about the mains power supply, the
nature of the power and the fuses to be used are
given on the washing machine name plate at the
back of the washing machine.
If the washing machine is directly connected to the electrical installation
(fixed connection), insert a two-pole switch with a contact opening distance
of not less than 3 mm.
This washing machine can only be connected to 220-230 V single phase
power supply.
Check that the subscriber’s meter and fuses are capable of carrying the
current required by the washing machine, allowing for other electrical
equipment connected at the same time.
Rating of line fuses (one for each phase):
10 A in 220-230 V single phase.
Important:
The installation shall comply with with the rules in force.
Use a power outlet with an earthing pin, which shall be connected
according to the rules in force.
If the mains power supply cable has to be replaced, have the work done by
the After Sales Service to make sure that it is done safely.
Make sure that the earthing connector is conform with the rules in force.
We cannot be held responsible if accidents or incidents are caused by a
non-existent or defective earth.
Installation and connection instructions