Electrolux LAVAMAT 42230 - Manual (Page 24)

24
Changing the spin speed
The spin speed can still be changed or the RINSE HOLD position " " set,
while the programme is running.
1. Press the START/PAUSE pushbutton " " .
2. Change the spin speed with the Spin Speed/RINSE HOLD pushbutton.
3. Press the START/PAUSE pushbutton " " again. The washing programme
continues.
Washing cycle complete/removing the washing
Once a washing programme cycle ended, the END light " " illuminates
on the Programme Progress Display.
If RINSE HOLD position
" " was selected, the indicator lights beside the
DOOR " " and END " " lights illuminate.
1. After a Rinse Hold, the water must first be drained:
– Either turn the programme selector to the OFF position " ", then turn
it to the DRAIN programme
" " and press the START/PAUSE pushbutton
" " (the water is drained without spinning),
or
– turn the programme selector to the OFF position " ", then turn it to the
SPIN programme and press the START/PAUSE pusbutton
" " (the water is
drained and the washing given a spin. The spin speed can also be changed
during the spin cycle).
When this stage of the programme is completed, the END light
" "
illuminates.
2. Open the door.
The door can be opened after the DOOR light
" " goes off and the END
light " " has come on.
3. Remove the washing.
4. Turn the programme selector to the OFF position " ".
5. Close the water tap.
6. Leave the drum and the lid open to air the washing machine.
Important! If the washing machine is not to be used for a long period,
close the water tap and disconnect the washing machine from the
electricity mains.
User's instructions