Electrolux EWG 12450 W - Manual (Page 37)

installation electrolux 37
ance power supply cable neeed to
be replaced, this must be carried
out by our Service Force Centre.
Note
When the appliance is installed the
power supply cable must be accessi-
ble.
Permanent connection
In the case of permanent connection it
is necessary that you install a double
pole switch between the appliance and
the electricity supply (mains), with a
minimum gap of 3mm between the
switch contacts and of a type suitable
for the required load in compliance with
the current electrical regulations.
The switch must not break the yellow
and green earth cable at any point.
Building-in
This appliance has been designed to
be built into the kitchen furniture. The
recess should have the dimensions
shown in picture A.
When installing the appliance into the
kitchen furniture ensure, if possible, the
hoses are placed in either of the two
recesses on the back of the appliance.
P0965
82
0
min
570 min.
600
596
41
6
17
6,
5
818
541 195
490
16
0
12
0
90
8
515
165 A
600
This will help to prevent the hoses from
becoming kinked or trapped.
Preparation and assembly of the
door
The machine is originally pre-arranged
for the assembly of a door opening
from right to left.
In this case it is sufficient to screw in
the hinges (1) and the counter-magnet
(6) provided with the appliance, at the
right level (Fig. B).
a) Door
The dimensions of the door should be:
- width
595-598 mm
- thickness 16-22 mm
The height (C-Fig. C) depends on the
height of the adjacent furniture's base.
35 Ø 14 prof.
16-22
B
C
22+1,5
595-598
416
P0422
C
4
6
5
1
2
3
7
B
P0982
132964710.qxd 19/07/2008 12.21 Page 37