Electrolux EWG 12450 W - Manual (Page 34)

Place the drain hose into your stand-
pipe, which should have an internal
diameter of approximately 38mm thus
ensuring there is an air break between
the drain hose and standpipe.
When discharging into a standpipe
ensure that the top of the standpipe is
no more than 90cm (35.4'') and no
less than 60cm (23.6'') above floor
level.
The drain hose may be extended to a
maximum of 4 metres. An additional
drain hose and joining piece is available
from your local Service Force Centre.
The joining piece must have an internal
diameter of 18 mm.
3 pin
Min.
60 cm (23.6”)
Max.
90 cm (35.4”)
BI0015
BI0014
30 cm (12")
38 mm (11.2”)
standpipe
diameter
34 electrolux installation
If your drain hose looks like this (see
below) you do not require the “U”
piece”. Just push the hose firmly into
the standpipe.
2. Onto a sink outlet spigot.
If the outlet spigot has not been used
before, remove any blanking plug that
may be in place.
Push the drain hose onto the spigot
and secure with a clip, ensure a loop is
formed in the drain hose (see diagram)
to prevent waste from the sink entering
the washing machine.
The drain hose may be extended to a
maximum of 4 metres. An additional
drain hose and joining piece is available
from your local Service Force Centre.
The joining piece must have an internal
diameter of 18 mm.
P1197
P1212
132964710.qxd 19/07/2008 12.21 Page 34