Electrolux EWG 12450 W - Manual (Page 33)

3. Set the hose correctly by loosening
the ring nut.
After positioning the inlet hose, be
sure to tighten the ring nut again to
prevent leaks.
4. Connect the hose to a tap with a 3/4”
thread. Always use the hose supplied
with the appliance.
The inlet hose must not be lengthened.
If it is too short and you do not wish to
move the tap, you will have to
purchase a new, longer hose specially
designed for this type of use.
Water-stop device
The inlet hose is provided with a water
stop device, which protects against
damage caused by water leaks in the
hose which could develop due to
natural ageing of the hose. This fault is
shown by a red sector in the window
«A». Should this occur, turn the water
tap off and refer to your Service Centre
to replace the hose.
A
P0352
P0351
Note !
Installation should comply with
local water authority and building
regulations’ requirements.
The appliance must be connected
to a cold water supply.
A minimum water pressure of 0.05
MPa (0.5 bar) is required for safe
operation of the appliance.
If you cannot make the cold water
connection direct from the rising mains,
you may be able to operate the
appliance from your cold water storage
system.
There should be a minimum vertical
distance of 5.02m (16.5 ft) between
the appliance’s inlet and the bottom of
the water storage tank.
Water drainage
This appliance is designed to be per-
manently plumbed into your home's
drainage system using one of the fol-
lowing methods.
1. Into a drainage standpipe
Firstly form a hook in the end of the
drain hose using the “U” piece” sup-
plied.
“U” piece
supplied
P1199
installation electrolux 33
132964710.qxd 19/07/2008 12.21 Page 33