Echo PB-410 - Manual (Page 16)

16
AIR FILTER
Level 1.
Tools required:
25 - 50 mm (1 - 2 in.) medium bristle cleaning brush.
Parts required: Air Filter
NOTE
Clean daily.
1. Close choke (Cold Start Position). This prevents dirt from entering
the carburetor throat when the air filter is removed. Brush accumu-
lated dirt from the air cleaner area.
2. Loosen both clamps of air cleaner cover, and remove filter as
shown.
3. Tap or lightly brush debris from air filter.
4. If element can be cleaned and reused, be certain it:
•still fits the cavity in the air cleaner cover.
•is installed with the original side out.
FUEL FILTER
Level 1.
Tools required: 200-250 mm (8 - 10 in.) length of wire with one end
bent into a hook, clean rag, funnel, and an approved
fuel container.
Parts required: Fuel Filter
DANGER
Fuel is VERY flammable. Use extreme care when mixing, storing or
handling.
1. Use a clean rag to remove loose dirt from around fuel cap and
empty fuel tank.
2. Use the “fuel line hook” to pull the fuel line and filter from the
tank.
3. Remove the filter from the line and install the new filter.
Fuel filter
Air cleaner cover Element
Clamp