Echo PB-410 - Manual (Page 13)

13
P
OWER
B
LOWER
O
PERATOR
’
S
M
ANUAL
STARTING COLD ENGINE
- Recoil starter: Use short pulls - only 1/2 - 2/3 of rope length for
starting. Do not allow the rope to snap back in. Always hold the unit
firmly.
- Rotate spring loaded throttle handle downward to a comfortable
operating position.
WARNING
When engine is started, confirm there is no vibration or sound. If
there is abnormal vibration or sound, ask your dealer to repair.
1. Turn switch to “RUN” position.
2. Move throttle lever to Start position.
3. Close choke (move choke lever down) and pull recoil starter
handle until engine fires or 5 pulls maximum.
4. Open choke and if necessary, restart engine.
NOTE
Allow engine to warm up before use.
STARTING WARM ENGINE
1. Turn switch to “RUN” position.
2. Move throttle lever to Start position, pull recoil starter handle 5
times and engine should start. Do not use choke.
NOTE
If engine does not start after 5 pulls, use cold start procedures.
STOPPING ENGINE
1. Move throttle lever to idle position and allow engine to run at idle
for a few minutes.
2. Move switch to “STOP” position.
WARNING
If engine does not stop, move choke lever to closed position to stall
engine. Check and repair stop switch before starting engine again or
serious personal injury may result.
Open choke
Close choke
Recoil starter handle
Choke lever
RUN
STOP
Idling
High speed
START