Electrolux 55750 - Manual (Page 8)

8
C Fill with 1 kg of special salt. As a result, approx. 1
litre of water will be displaced.
- Remove salt from around the opening of the disĆ
penser.
- Close the salt dispenser by turning the cap until
the stop is reached.
- Immediately run the "Pre-rinse"program to
wash away any salt residues.
Never fill the salt dispenser with rinse aid or
detergent!
The salt display will go out after 1 or 2 rinse cycles.
Do not remove the water feed valve, and do not
fill with detergent for any reason.
Setting the Water Softener
The dishwasher is equipped with a water softener deĆ
signed to remove minerals and salts from the water
supply, which would have a detrimental or adverse efĆ
fect on the operation of the appliance.
The higher the content of these salts, the harder your
water is.
The softener should be adjusted according to the hardĆ
ness of the water in your area. Your local Water authorĆ
ity can advise you on the hardness of the water in your
area.
Adjust the dosage as follows:
Turn the setting button using a coin or a screwdriver
until the arrow on the knob points to the desired numĆ
ber.
The arrow must point to a number and the poĆ
sition must be engaged positively.
Clarke
degrees
French degrees
( ° TH)
PPM (Parts
per Million) Level
0 - 9 0 - 12,5 0 - 125 1
9 - 18 12,5 - 25 125 - 250 2
18 - 26 25 - 37,5 250 - 375 3
26 - 35 37,5 - 50 375 - 500 4
> 35 > 50 > 500 5
The first wash cycle
- When using for the first time, use the Intensive proĆ
gram.
A
B
C
1
4
3
2
5