Electrolux 55750 - Manual (Page 7)

7
Prior to Using for the First Time
Carry out the following steps before using your dishĆ
washer for the first time.
Filling with Rinse Aid
Rinse aid is automatically added during the last rinse,
ensuring thorough rinsing, spot and streak free drying.
A If the rinse aid display light is lit on the control
panel, open the dispenser by turning the sealing
cap to the left.
B Fill with rinse aid up to the "max" mark. Do not exĆ
ceed the maximum container mark of 150 ml.
- Close the dispenser.
- Remove any spillage to prevent foaming.
The rinse aid display light on the control panel will go
out.
Setting the rinse aid dosage
According to the finish and drying results obtained, the
rinse aid dosage can be adjusted. Position 1 minimum
dosage, position 6 maximum dosage.
The factory setting is level 3.
Gradually increase the dosage if there are drops of waĆ
ter or lime spots on the dishes after washing. Reduce
it if there are sticky whitish streaks on the dishes.
Filling the salt dispenser
Warning! Only use special salt for dishwashers.
Other types of salt (e.g., cooking salt) often
contain water-insoluble components which
can block the water softener and may render
it unserviceable.
Salt and detergent packages often look very
similar. Detergent accidentally poured into the
salt dispenser will damage the water softener.
Each time you fill with special salt, ensure that
you are really holding a salt package in your
hand.
Fill with salt as follows:
A Open the cap of the salt dispenser.
B Fill the dispenser with water
A
B
A
B