Electrolux 55750 - Manual (Page 17)

17
Mains power loss
In case of a power failure, or a deliberate disconnection
to the power supply, all the set values are retained.
Error message
The electronics of the dishwasher can independently
recognise and display faults. If a fault occurs, an error
code in the display, one of the program control lamps
and the Program End symbol in the display will blink.
Please note down this error code before making conĆ
tact your Service Centre.
The error message is deleted by switching off the main
switch.
Error codes and possible causes
A = Water tap closed, inlet hose filter blocked
C = Drain hose, coarse or fine strainer or sink trap
blocked
E = Water pressure too low, water tap not comple-
tely opened, inlet hose or inlet hose filter is
blocked, machine losing water.
E2 = Call AEG Service force
H = Call AEG Service force
L = Call AEG Service force
Unloading the crockery basket
After the washing program is complete:
First unload the lower basket.
Then unload the upper basket, so that no drops of waĆ
ter fall onto the dry crockery in the lower basket.
Inspect the coarse strainer after every washing
sequence. Clean as necessary.
Programme
sequence display
Start time /
Remaining time
display
Mains switch