Peavey VSX 48e Programmable Loudspeaker Management System (1 RU, 4 Inputs, 8 Outputs) - Manual (Page 6)

6
( 11) IEC POWER CORD CONNECTION and Fuse Holder
This receptacle is for the IEC line cord (supplied) that provides AC power to the unit. It is very important that you ensure the unit
has the proper AC line voltage supplied.
Please read this guide carefully to ensure your personal safety as well as the safety of your equipment. Never break off the ground pin
on any equipment. It is provided for your safety. If the outlet used does not have a ground pin, a suitable grounding adapter should
be used and the third wire should be grounded properly. To prevent the risk of shock or fire hazard, always be sure that the mixer
and all other associated equipment are properly grounded.
Caution: For 195 to 240 VAC operation, a “F2AL 250V” fuse rated at 2 amps should be used.
(12) ON-OFF SWITCH
This rocker switch supplies AC power to the unit when switched to the ON position. The ON position is with the top side of the
switch pushed “in” or nearly flush with the rear panel.
(13) Ethernet Control Interface
Ethernet port for control of the VSX using the graphical user interface.
(14) D sub 9 connector
Connection for RS232 and RS485 serial control.
(15) OUTPUTS
XLR balanced outputs 1-6 or 1-8.
(16) INPUTS
XLR balanced inputs A and B or A, B, C and C.
Operating the VSX processors from the front panel is made simple by a wide array of buttons and a simple
intuitive interface.
Opening screen shows product name and firmware version.
After a brief time out, the currently active preset is displayed.
Operation