Geekoto GT200 Monolight Full Kit - Manual (Page 8)

This flash has three flash modes: TTL, Manual (M), and Multi (Strobe).
In TTL mode, the camera and the flash will work together to calculate the
correct exposure for the subject and the background.
Press < Mode/ > button to cycle through all three flash modes.
TTL Mode
Press > button to enter TTL mode. The AV panel is displayed < TTL >.
TTL Autoflash
Flash Compensation
With flash compensation function, this flash can adjust from -3 to +3 in
1/3rd stops. It is useful in situations where minor adjusting of the TTL
system is needed based on the environment.
Setting Flash Compensation:
• Press <+>, “+0.3” means 1/3 step, “+0.7” means 2/3 step.
• Press <->, “-0.3” means 1/3 step, “+0.7” means 2/3 step.
•To cancel flash compensation, set the amount to “+0”.
High-Speed Sync
High-Speed Sync (FP flash) enables the flash to synchronize with all camera
shutter speeds. This is convenient when you want to use aperture priority for
fill-flash portraits.
• With high-speed sync, the faster the shutter speed, the shorter the
effective flash range.
• Multi-strobe mode cannot be set in high-speed sync mode.
Manual Flash
In manual mode, you can cycle through all the power output 1/128 to 1/1
in 1/3-stop increments.
For a proper exposure, please use an external flash meter or the meter
within the camera.
1.Press > button, until the AV panel display .
2.Press <+> <-> button to set desired flash output.
- 11 - - 12 -