Geekoto GT200 Monolight Full Kit - Manual (Page 10)

• Stroboscopic flash is most effective with a highly reflective subject against a dark
background.
• Using a tripod and a remote control is recommended.
• A flash output of 1/1 and 1/2 cannot be set for stroboscopic flash.
• Stroboscopic flash can be used with”buLb”.
• If the number of flashes is displayed as “--”, the firing will continue until the
shutter closes or the battery is exhausted. The number of flashes will be limited
as shown by the following table.
Maximum Stroboscopic Flashes
1 / 4
1 / 8
1 / 16
1 / 32
1 / 64
1 / 128
1
7
14
30
60
90
90
2
6
14
30
60
90
90
3
5
12
30
60
90
90
4
4
10
20
50
80
90
5
4
8
20
50
80
90
6 - 7
3
6
20
40
70
90
8 - 9
3
5
10
30
60
80
Flash
output
Hz
10
2
4
8
20
50
70
11
2
4
8
20
40
70
12 - 14
2
4
8
20
40
60
15 - 19
2
4
8
18
35
50
20 - 50
2
4
8
16
30
40
60 - 99
2
4
8
12
20
40
Group Setting / Channel Setting
GT-200 adopts GEEKOTO 2.4G wireless system, which has good compatibility
with other products of our lineup.
As a slave unit, GT-200 is automatically compatible with Canon / Nikon /
Sony / Fujifilm TTL system according to the master unit.
By using GEEKOTO C1(Commander) trigger you can use one or more
GT-200-TTL flashes simultaneously.
1.Setting Communication Group
Short press wireless button to switch group in A / B / C / D.
Long press wireless button till “CH 1” flashes on the AV panel. Then
press <+> <-> to switch channel from 1 to 16.
- 15 - - 16 -
2.Setting Communication Channel