Geekoto GT200 Monolight Full Kit - Manual (Page 7)

Lithium Battery Power Management
1.This flash unit uses Li-ion polymer battery which has a long service life.
When the battery is fully charged, it will offer 500 times of charge and
discharge cycles.
2.Battery is safe and reliable. The inner circuit of the battery is designed
against over-charge, over-discharge, over-current and short circuit.
3.This battery takes only four hours to be fully charged.
Cautions
1.Do not short circuit.
2.Do not expose to moisture or submerge into water. This battery is not
waterproof.
3.Keep out of reach of children.
4.Do not charge the battery continuously over 24 hours.
5.Store in dry, cool, ventilated places.
6.Do not dispose in fire.
7.Scrapped batteries should be disposed of according to local regulations.
8.Please charge the battery to 60% for long-term storage.
9.If the battery has been stored for over 3 months, please recharge the
battery.
Battery Level Indication
Make sure the battery pack is securely loaded in the flash. Check the
battery level indication on the AV panel to see the remaining battery level.
Features
Battery Level
Indication on the
AV Panel
3 Bars
2 Bars
1 Bar
Blank
Blinking
Meaning
Full battery
Medium battery
Low battery
Lower battery, please recharge.
Battery exhausted, the flash will auto power off in 1
minute.
Note: when in this state, Please recharge the battery
as soon as possible (within 10 days).
Then the battery can be used or be placed for long
periods.
ON/OFF Power Switch controls the on/off of the flash unit, please turn
off the power when not in use. This product is designed with automatic
standby feature, it will go to standby mode when not operated, (approx.
30/60 minutes).
Modeling Lamp
Wireless Flash Mode
GT-200 can only be set as a slave unit (receiver end). Long press the
wireless selection button for 2 seconds to switch the radio transmission
function.
Wireless Mode
OFF
Radio Transmission
Flash Mode
M / Multi
TTL / M / Multi
- 09 - - 10 -
Long press > button
until the display on the AV panel
for turning on the LED modeling
lamp.