Electrolux 12830 - Manual (Page 52)

Water inlet (cold water connection only)
Connect the hose to a tap with a 3/4” thread.
Installation should comply with local water
authority and building regulations’ require-
ments.
The inlet hose is provided with a water stop
device, which protects against damage
caused by water leaks in the hose which
could develop due to natural ageing of the
hose. This fault is shown by a red sector in
the window “A”. Should this occur, turn the
water tap off and refer to your Service Force
Centre to replace the hose.
Set the hose correctly by loosening the ring
nut. After positioning the inlet hose, be sure
to tighten the ring nut again to prevent
leaks.
Do not connect to a hot water supply.
Water drainage
TThis appliance is designed to be perma-
nently plumbed into your home's drainage
system using one of the following methods.
1. Into a drainage standpipe.
Firstly form a hook in the end of the drain
hose using the “U” piece” supplied.
Place the drain hose into
your standpipe, which
should have an internal
diameter of approximately
38mm thus ensuring there
is an air break between the
drain hose and standpipe.
52
Installation
A
P0352
P1199
“U” piece
supplied
P1074
30 cm (12")
38 mm (11.2”)
standpipe
diameter
132984010.qxd 24/06/2005 16:30 Pagina 52