Electrolux 12830 - Manual (Page 37)

Remove any
objects from the
pump impeller by
rotating it.
Put the cap back
on the emergency
emptying hose
and place the lat-
ter back in its
seat.
Screw the pump fully in.
Close the pump door.
Water inlet filter
If you notice that the machine is taking longer to fill, check that the
filter in the water inlet hose is not blocked.
Turn off the water tap.
Unscrew the hose from the tap.
Clean the filter in the hose with a stiff brush.
Screw the hose back onto the tap.
Emergency emptying out
If the water is not discharged, proceed as follows to empty out the
machine:
• pull out the plug from the power socket;
• close the water tap;
• if necessary, wait until the water has cooled down;
• open the the pump door;
• place a bowl on the floor and place the end of the emergency
emptying hose into the bowl. Remove its cap. The water should drain
by gravity into the bowl. Whe the bowl is full, put the cap back on
the hose. Empty the bowl. Repeat the procedure until water stops
flowing out;
• clean the pump if necessary as previously described;
• replace the emergency emptying hose in its seat after having plug-
ged it;
• screw the pump again and close the door.
37
Cleaning and maintenance
P1097
132984010.qxd 24/06/2005 16:30 Pagina 37