HP E27q 27" 16:9 IPS Monitor - Manual (Page 26)

NOTE: When the power mode is set to Performance, the USB hub and USB ports remain on, even when
the monitor is in sleep mode.
Using Auto-Sleep Mode
The monitor supports an OSD menu option called Auto-Sleep Mode that allows you to enable or disable a
reduced power state for the monitor. When Auto-Sleep Mode is enabled (enabled by default), the monitor
enters a reduced power state when the computer signals low power mode (absence of either horizontal or
vertical sync signal).
Upon entering this reduced power state (sleep mode), the monitor screen is blanked, the backlight turns off,
and the power light turns amber. The monitor draws less than 0.5 W of power when in this reduced power
state. The monitor wakes from sleep mode when the computer sends an active signal to the monitor (for
example, if you activate the mouse or keyboard).
To disable Auto-Sleep Mode in the OSD:
1. Press the Menu button to open the OSD.
2. In the OSD, select Power.
3. Select Auto-Sleep Mode, and then select Off.
Using low blue light
Decreasing the blue light emitted by the monitor reduces the blue light exposure to your eyes.
This monitor uses a low blue light panel default setting mode, that when used in the default setting mode, is
certified by TÜV to reduce blue light output and create a more relaxing and less stimulating image while
reading content on the screen.
WARNING! To reduce the risk of serious injury, read the Safety & Comfort Guide provided with your user
guides. It describes proper workstation setup and proper posture, health, and work habits for computer
users. The Safety & Comfort Guide also provides important electrical and mechanical safety information. The
Safety & Comfort Guide is also available on the Web at http://www.hp.com/ergo .
20 Chapter 2 Using the monitor