beautypg.com

Mounting the monitor head (select products only), Removing the monitor stand – HP E27q 27" 16:9 IPS Monitor User Manual

Page 13

background image

Mounting the monitor head (select products only)

The monitor head can be attached to a wall, swing arm, or other mounting fixture.

IMPORTANT:

This monitor supports the VESA industry-standard 100 mm mounting holes. To attach a third-

party mounting solution to the monitor head, use four 4 mm, 0.7 pitch, and 10 mm long screws. Longer

screws might damage the monitor. Be sure to verify that the manufacturer’s mounting solution is compliant

with the VESA standard and is rated to support the weight of the monitor head. For best performance, use the

power and video cables provided with the monitor.

NOTE:

This apparatus is intended to be supported by a UL-listed or CSA-listed wall-mount bracket.

Removing the monitor stand

IMPORTANT:

Before disassembling the monitor, be sure that the monitor is turned off and all cables are

disconnected.

1.

Disconnect and remove all cables from the monitor.

2.

Position the monitor facedown on a flat surface covered by protective sheet made of foam or a clean,

dry cloth.

3.

Push up the latch near the bottom center of the stand’s mounting plate (1).

4.

Swing the bottom of the stand up until the mounting plate clears the recess in the monitor head (2).

5.

Slide the stand out of the recess (3).

Setting up the monitor

7