Eizo Flexscan S2133 21.3" 4:3 IPS Monitor - Manual (Page 33)

33
Chapter5Troubleshooting
5-3. Imaging problems (for digital only)
Problem Possible cause and remedy
1. The monitor configuration is changed to
single under the multiple monitor configu-
ration (when DisplayPort is connected).
• WhentwomonitorsareconnectedtoonePCusing
DisplayPort,andthepowertooneofthemonitorsis
turnedoffwiththepowerbutton,thescreensettingmay
bechangedtothesinglemonitorconfiguration.Insucha
case,enablethe“DPHotPlug”functionwiththefollowing
procedures.Enablingthisfunctionmayincreasethe
powerconsumption.
1. Press toturnoffthemonitor.
2. Holddown whilepressing toturnonthe
monitor.
Eachtimetheoperationenables/disablesthisfunction
alternatively.
Thecurrentsettingstatuscanbeidentifiedbasedonthe
colorusedtodisplaytheinputportorsignalerror.
Setting Input port Signal Error
Disable
(default
setting)
Enable
5-4. Imaging problems (for analog only)
Problem Possible cause and remedy
1. Display position is incorrect. • Use“Position”intheSettingmenutocorrecttheimage
position(see “Tocorrectthescreenposition”(page22) ).
• Iftheproblempersists,usethegraphicsboard’sutilityif
availabletochangethedisplayposition.
2. Vertical bars appear on the screen or a
part of the image is flickering.
• Use“Clock”intheSettingmenutoadjustit(see “To
eliminateverticalbars”(page21) ).
3. Whole screen is flickering or blurring. • Use“Phase”intheSettingmenutoadjustit(see “To
removeflickeringorblurring”(page22) ).