2. attaching the optional arm, 3. attaching the original stand, 3. attaching the original stand 1 – Eizo ColorEdge CS2740 26.9" 16:9 Wide Gamut 4K IPS Monitor User Manual
Page 40
40
Chapter 7
Attaching/Detaching the Stand
7-2. Attaching the Optional Arm
An optional arm (or an optional stand) can be attached by removing the stand section. Please refer to our
web site for the corresponding optional arm (or optional stand).
Attention
•
When attaching an arm or stand, follow the instructions of their User's Manual.
•
When using another manufacturer's arm or stand, confirm the following in advance and select one conforming
to the VESA standard. Use the VESA mounting screws supplied with this product when attaching the arm or
stand.
- Clearance between screw holes: 100 mm x 100 mm
- External dimensions of the VESA mount section of the arm or stand: 122 mm x 122 mm or less
- Plate thickness: 2.6 mm
- Must be strong enough to support weight of the monitor unit (excluding the stand) and attachments such as
cables.
•
When using an arm or stand, attach it to meet the following tilt angles of the monitor.
- Up 45˚, down 45˚
•
Connect the cables after attaching an arm or stand.
•
Since the monitor and arm or stand are heavy, dropping them may result in injury or equipment damage.
•
When installing the monitor in portrait mode, turn the monitor screen 90˚ in clockwise direction.
1.
Attach the arm or stand to the monitor.
Use the VESA mounting screws supplied with this product when attaching the arm or stand.
7-3. Attaching the Original Stand
1.
To prevent damaging the LCD panel surface, lay the monitor with its LCD panel
surface facing down on a soft cloth spread on a stable surface.
2.
Remove the fixing screws on the optional arm (or optional stand), and detach
the optional arm (or optional stand).
3.
Attach the original stand.
Insert the four tabs on the stand into the square holes on the back panel (
1
) and slide the stand
towards the upper portion of the monitor until it makes a clicking sound (
2
).
(1)
(2)
(2)