Asus ProArt Display OLED PA32DC 31.5" 4K HDR Monitor - Manual (Page 22)

2-6
Chapter 2: Setup
2.5 Installing the cable clips
Use the cable clips to manage the connected cables.
To install the cable clips:
1.
Using a paperclip (or similar item), remove the rubbers covering the screw
holes (Figure 1).
2. By aligning the screw hole (marked by blue line) and the guide pin (marked
by the pink line) of the cable clip with the screw holes, install the clip to its
designated location on the rear of the monitor. Then secure the cable clip
with the screw (Figure 2).
Repeat the same steps to install other cable clips.
• Make sure the guide pin is installed into the screw hole closer to the
edge of the monitor.
• The cable clip is divided into two sides (left and right).
3. Route the connected cables through the installed cable clips (Figure 3).
(Figure 1) (Figure 2)
(Figure 3)