Erica Synths EDU DIY Mixer Eurorack Module Kit - Manual (Page 45)

45
Now, insert the ICs into their respective
DIP sockets. Mind the orientation of the ICs
– match the notch on each IC with the one on
its socket.
Congratulations! You have completed the assembly of the mki x es.edu Mixer module!
Connect it to your eurorack power supply and switch it on. If there’s no & magic smoke”, it’s
a good sign that your build was successful. Patch some audio signals (your DIY.EDU VCO will
be the best choice – patch the Pulse and Saw outputs into IN1 and IN2 of the mixer
respectively) to the input of the module and connect the OUT of the module to a mixer. Adjust
levels of IN1 and IN2 and observe, how different amounts of each signal alter the timbre
of the mixed signal. Connect the CLIP OUT of the module to a mixer and observe, how the
audio signal gets distorted with IN1 and IN2 levels being increased. Now you can
proceed with calibration, which consists of adjusting the multiturn trimpot for desired for
desired clipping amount. Please, follow instructions above! Enjoy!