Eurocave INOA 50 - Manual (Page 19)

- Programming the remote control
Where placing the remote control outside the cellar, having connected the external sensor, it is essential to reprogramme the uni t
- To turn on the remote control, press and hold down the key for about 8 seconds until the indicator goes off.
- First press and continuously hold down the key, at the same time press and continuously hold down the key for several seconds until three
lines appear.The model number is then displayed and flashes. .
- Press .
- The screen appears indicating IN (IN= internal installation). Press the key to change to OUT external mode.
- The display appears indicating OUT (OUT= external installation). Press to confirm.
- The pictogram appears. Press .
- The screen appears. Press .
- The pictogram appears. Press .
- .appears. Press .
- The pictogram appears. Press .
- The screen appears, then .
If you wish to reprogramme the remote control for an internal sensor, disconnect the wired sensor and reprogramme the remote control in internal mode
(IN) by repeating the first two steps described in the paragraph above (see 5-III-b p.11):
The 2nd screen displays indicating OUT (OUT= external installation). Press the key to change to IN internal mode. Press to
confirm.
Then repeat the same steps, as indicated in the above paragraph (see 5-III-b).
c- Fitting
- Fit the remote control and sensor using the screws and pegs supplied (see diagram on page 9, chapter II).
- Place the sensor inside the cellar.
- Place the sensor as close as possible to the bottles
N.B.: the sensor has a range of 3 metres.
9 - I
NSTALLING THE REMOTE CONTROL
17