SPYPOINT Force-20 Trail Camera (Brown) User Manual
Page 8
A memory card is required to save photos. The camera is only compatible with SD memory cards that have a
maximum capacity of 32 GB (sold separately).
When the camera is turned on and no memory card is inserted, the screen will display the message “No card”
This table indicates the approximate number of photos that can be stored on various memory card capacities.
inserting the memory card
Before inserting or removing a memory card, always turn the camera OFF to prevent any loss or damage to photos
already saved on the memory card. Also, make sure the switch on the side of the SD card is not set on LOCK.
Insert a standard SD/SDHC memory card (up to a 32 GB capacity) in the SD card slot with the label facing up. The card
is inserted correctly when a click is heard.
removing the memory card
Gently press down on the exposed edge of the memory card once to eject and remove the card from the slot.
memory card and test light / 6
memory card
test light
In SETUP mode :
The light flashes when motion is detected. It also allows the user to verify that the
intended detection distance is adequate during installation.
In ON mode :
The light flashes for 30 seconds to allow the user to leave the area, after the installation,
without being photographed.
memory
4 GB
8 GB
16 GB
32 GB
20 MP Photos
3,800
7,600
15,200
30,400
1280 x 720 videos
40 min
1h20
2h40
5h20
We recommend formatting your SD card whether or
not it was used in another device before, thus ensuring
that you benefit from its full memory capacity.
Quick formatting is NOT recommended for this task.