SPYPOINT Force-20 Trail Camera (Brown) - Manual (Page 11)

recommended settings
The camera can be configured for usage in trails . This configuration is best suited for lower activity levels, fast moving subjects and fewer
photos. These settings increase the chances of capturing animals following one another.
The camera can also be configured for usage at a
feed site . This configuration is best suited for higher activity levels, slow moving subjects and
more photos. This configuration will reduce the number of photos taken while capturing all the activities on the feeding site.
The below table shows the suggested settings for both configurations:
main menu / 9
photo mode
- Sets the options for the
PHOTO mode.
configuring the settings for the 3 modes of operation
Delay (Instant/5s/10s/30s/1m/3m/5m/10m/15m/30m)
Allows the user to choose the delay between each detection before the camera takes the next photo. A
longer delay minimizes the number of photos taken and maximizes battery life. A shorter delay maximizes
the number of photos taken but requires more battery power. Shorter delays are recommended when the
camera is used for security purposes.
quality (3 MP or 20 MP) Allows you to select a resolution of 3 MP or 20 MP.
Multishot ( Multi ) (1/2/3/4/5 consecutive photos) Allows you to take up to 5 consecutive photos per detection with a delay of 5 seconds between each photo.
sensitivity
(
detect
)
(Auto, Low, Medium, High)
Allows to choose the sensitivity level of the motion sensor. Once you have made your selection, press OK.
Higher sensitivity will increase the number of photos taken. Make sure the front of the camera is free of any
obstruction. The area of installation should be cleared from branches or bushes.
trail feed
Delay Instant 5 m
multishot 1 1-5
Battery life can be compromised if the settings of your
camera are not adapted to the actual situation.