SPL Hermes Mastering Router with Dual Parallel Mixes (Red) - Manual (Page 16)

14
Control Elements
1 Insert buttons A-H
With the insert buttons A to H, you can activate or deactivate the respective Insert.
Furthermore, the order of the selection corresponds with the order of the inserts of the
mastering chain. If you (for example) first activate insert D and then insert B afterwards,
this will also correspond to the signal flow, which means that the signal is firstly sent to
insert D and then to insert B.
2 New [Delete]
By activating the NEW button, you can create a new processing chain. All Inserts, which
were previously activated, will be deactivated and the order which was previously set
with the inserts and the linkings of the Parallel Mix are deleted. Now you can create a
completely new processing chain.
The button has a further function on a second level (Label Mode). In this mode you can
delete letters and characters with the DELETE button.
3 Store [Hold 2s to Label]
You can store a processing chain with the STORE button. If you press the STORE button, it
lights up red and the Preset buttons start to blink orange. In this mode, a storage space
for the active insert chain can now be selected with the Preset button.
On the second functional level, this button activates the Label Mode. To switch to the Label
Mode, press the button for two seconds. If the Label Mode is active, the STORE button
blinks red and the insert button orange. If you now select an insert, it can be labeled. The
button of the selected insert now light up orange and the STORE button keeps on blinking
red. If you press the STORE button again, you can end the Label Mode
4 Preset 1 [< ABC]
With the button 1 in the Preset section, you can activate or store Preset 1.
On the second functional level, this button enables the selection of letters in Label Mode.
The selection runs in the opposite direction compared to the normal order of letters, hence
Z, Y, X, …
5 Preset 2 [ABC >]
With the button 2 in the Preset section, you can activate or store Preset 2.
On the second functional level, this button enables the selection of letters in Label Mode.
The selection runs in the normal order of letters, hence A, B, C, …