SPL Hermes Mastering Router with Dual Parallel Mixes (Red) - Manual (Page 12)

10
Rear Side: Connections
1 Sends A-D (left)
In the Sends A-D (left) section, Hermes provides four balanced output jacks. These are
male XLR jacks. These outputs send the signal for the left input channels of connected
devices.
2 Sends A-D (right)
In the Sends A-D (right) section, Hermes provides four balanced output jacks, male XLR.
These outputs send the signal for the right inputs of connected devices.
3 Returns A-D (left)
In the Returns A-D (left) section, Hermes provides four balanced input jacks. These are
female XLR jacks. These outputs receive the signal for the left output channels of con-
nected devices.
4 Returns A-D (right)
In the Returns A-D (right) section, Hermes provides four balanced input jacks, male XLR.
These inputs receive the signal of the right outputs of connected devices.
5 Sends / Returns E - H (left)
For the Sends / Returns (left) a DB25 connector is provided. The four Sends send the sig-
nal for the left inputs of connected devices. The four Returns receive the signal of the left
outputs of connected devices. The pin assigment corresponds to Tascam standard (see
page 7). To connect external devices, you should use a cable with four XLR, male and four
XLR, female. The inputs (Returns) are located on positions 1-4. The outputs (Sends) on
positions 5-8.
6 Sends / Returns E - H (right)
For the Sends / Returns (right) a DB25 connector is provided. The four Sends send the
signal for the right inputs of connected devices. The four Returns receive the signal of the
right outputs of connected devices. The pin assigment corresponds to Tascam standard
(see page 7). To connect external devices, you should use a cable with four XLR, male and
four XLR, female. The inputs (Returns) are located on positions 1-4. The outputs (Sends)
on positions 5-8.