SPL Performer m1000 Mono Power Amplifier (Red) - Manual (Page 16)

16
AMP CTL (Standby / Amplifier Control)
If you own an SPL device supporting AMP CTL output(s) you can trigger standby and
operation. Therefore connect the AMP CTL output of the SPL device with a mono mini
jack cable to the
AMP CTL (10) of the Performer m1000.
You may also use other 12V trigger controller. The Performer m1000 is in operation
mode when a switching voltage of 12 Volt DC is applied to the AMP CTL input.
As soon as the 12 Volt DC is removed, the Performer m1000 switches back to
standby mode.
Use a mono mini jack cable where the tip is plus and the sleeve is minus.
Power LED
In standby the Power LED is dimly lit.
If the Performer m1000 is in operation, the Power LED lights up brightly.
If the Performer m1000 is off, e.g. the mains switch is off, the Power LED is off.
XLR WIRING:
Pin 1 = GND
Pin 2 = Hot (+)
Pin 3 = Cold (–)
Minimum Load:
2 Ω
INPUT
THRU INPUT
TRIM
INPU T
AM P CTL/ 12V T RIG GER
SPE AKE R OUT PUT
SPEAKER OUTPUT
+ –
AMP CTL/12V TRIGGER
Connect to
SPL devices
supporting
AMP CTL
for remote
standby on/off.
0 -5.5
-5
-4
.5
-4
-3.5
- 3 -2 .5
-2
-1
.5
-1
-0.5
Tip
Sleeve
I F R