SPL Performer m1000 Mono Power Amplifier (Red) - Manual (Page 14)

14
Protection circuits
The Performer m1000 has protection circuits against DC (direct current) voltage at the output and against
overheating.
DC Protection
If DC is detected at the output, the Performer m1000 automatically switches off. DC voltage can be an indication
for a defective power stage. The
ProtectLED (3) on the front indicates that the protection circuit is activated and
the power stage has been switched off.
The Performer m1000 does not automatically switch on again. It needs to be switched off manually with the
mains switch (6). Wait at least one minute before switching the Performer m1000 on again.
If the Performer m1000 repetitively switches off due to a DC detection please contact your dealer.
I F R