Speaker output, I f r – SPL Performer m1000 Mono Power Amplifier (Red) User Manual
Page 13
13
Speaker output
You can connect a 2, 4 or 8 ohms loudspeaker to the
.
You can either use the ø4 mm cable hole (screwable) or the banana
plugs of the gold-plated loudspeaker binding posts.
Make sure that you do not mix up the polarity of the speaker connections and that the power amplifier is switched
off when you connect speaker cables.
XLR WIRING:
Pin 1 = GND
Pin 2 = Hot (+)
Pin 3 = Cold (–)
Minimum Load:
2
Ω
INPUT
THRU
INPUT
TRIM
INPU
T
AM
P CTL/
12V T
RIG
GER
SPE
AKE
R OUT
PUT
SPEAKER OUTPUT
+
–
AMP CTL/12V TRIGGER
Connect to
SPL devices
supporting
AMP CTL
for remote
standby on/off.
0 -5.5
-5
-4
.5
-4
-3.5
- 3
-2
.5
-2
-1
.5
-1
-0.5
I F R