Sony SRG-120DU USB 3.0 Full HD PTZ Camera - Manual (Page 14)

14
l OUTPUT (audio output) connector (3.5 mm
diameter, stereo mini jack)
Connect one end of the supplied XLR-BMP conversion
output cable for the URX-P40 or the stereo mini plug-
BMP conversion cable here and the other end to the
microphone input on a camcorder, mixer, or amplifier. If
the microphone input connector on the connected device
is a stereo mini jack, connect the straight (BMP) plug to
the tuner and the L-shaped (stereo mini) plug to the
microphone input connector on the device.
To prevent damaging the tuner, do not apply a voltage to
this connector from a microphone external power supply
or other source.
m Auxiliary connector
Used to connect external accessories.
n USB connector (Type C)
Connect to a commercially available USB portable power
supply.
When the power is turned on, the unit operates with
power supplied by the USB portable power supply.
Power Supply
This section describes the power supply of each device.
Body-pack transmitter (UTX-B40) and plug-on
transmitter (UTX-P40)
The unit operates using power supplied from two AA
batteries (alkaline, nickel metal hydride, or lithium
batteries) or from a supply connected to the USB
connector. If power is supplied simultaneously from
batteries and from a supply connected to the USB
connector, power from the USB connector has
precedence. For details about inserting batteries in each
device and displaying the battery level, or supplying
power from a supply connected to the USB connector, see
the following sections.
Hand-held microphone (UTX-M40)
The unit operates from two AA batteries (alkaline, nickel
metal hydride, or lithium batteries). For details about
inserting batteries and displaying the battery level, see the
following sections.
Portable diversity tuner (URX-P40)
The unit operates from two AA batteries (alkaline, nickel
metal hydride, or lithium batteries), power supplied from
a supply connected to the USB connector, or power
supplied from the auxiliary connector. The power supply
that has precedence when both AA battery power and an
external power supply via the USB connector or auxiliary
connector are available can be specified using the
POWER SOURCE (external power selection) function.
Under the factory default setting, the power supplied from
inserted AA batteries has precedence. For details about
inserting batteries and displaying the battery level, or
supplying power from supply connected to the USB
connector, see the following sections.
For details on the POWER SOURCE function setting, see
“Selecting the preferred power supply (POWER
SOURCE)” (page 25).
The use of manganese batteries will result in poor
performance. Do not use manganese batteries.
Inserting the batteries
• Always use sets of the same type of battery. Do not use
batteries of different types or batteries with different
charge level together.
• Replacing the batteries during operation may generate
a large noise. Be sure to turn off the unit before
replacing the batteries.
Function Operation
Supply ON Press button for one second or
longer
Supply OFF Press button until the indicator turns
off
Note
Note
Notes