Sony WH-XB910N EXTRA BASS Noise-Canceling Wireless Over-Ear Headphones (Black) - Manual (Page 10)

10
(US)
3
Attach the Wall-Mount Bracket
(not supplied) using the screws
(not supplied).
When using an electric screwdriver, set the torque
setting to approximately 1.5 N·m {15 kgf·cm}.
Do not lift the Mounting Hook before the screws
(two screws each for left/right) are secured. This
may distort the Mounting Hook or the LCD Display
cabinet.
4
Detaching the Table-Top Stand
from the LCD Display.
To detach the Table-Top Stand from the LCD
Display, remove the screws .
Note
• Be careful when lifting the LCD Display as the Table-
Top Stand is detached, the Table-Top Stand may
topple over and cause personal injury.
• Take care when removing the Table-Top Stand from
the LCD Display to prevent it from falling over and
damaging the surface that the LCD Display is sitting
on.
• Do not remove the Table-Top Stand for any reason
other than to install corresponding accessories on
the LCD Display.
• Be sure the LCD Display is vertical before turning
on. To avoid uneven picture uniformity do not
power on the LCD Display with the panel facing
down.
• When attaching the Table-Top Stand again, be sure
to fasten the screws (previously removed) to the
original holes on the rear of the LCD Display.
Screw (not supplied)
Wall-Mount Bracket
(not supplied)
FW-75BU30J / 65BU30J / 55BU30J / 50BU35J /
50BU30J / 43BU35J / 43BU30J / 75BZ30J /
65BZ30J / 55BZ30J / 50BZ35J / 50BZ30J /
43BZ35J / 43BZ30J
1
Remove the screws from the
rear of the LCD Display.
When using an electric screwdriver, set the torque
setting to approximately 1.5 N·m {15 kgf·cm}.
Do not lift the Mounting Hook before the screws
(two screws each for left/right) are secured. This
may distort the Mounting Hook or the LCD Display
cabinet.
2
Attach the Wall-Mount
Attachment (supplied with the
LCD Display) to the rear of the
LCD Display (to make it parallel
with the wall).
VS
VS
Supplied with the
LCD Display
Wall-Mount
Attachment (4)
1.5 N·m
{15 kgf·cm}