Sony FA-WRC1M Wireless Radio Commander - Manual (Page 19)

Attaching to the Camera 19
Note
Orient the lens side face down when placing the
removed imager block on a flat surface. If the heat
sink side is placed face down, the flangeback
(flange focal distance) may be adversely affected.
2
Attach the imager block, removed in
step
1 , to the imager block adapter.
Align and attach using the four supplied hex
screws, and tighten using a hex wrench
(tightening torque of 1.4 N·m).
3
Attach the camera body adapter ( 1 )
and then attach the bottom plate ( 2 ).
Align and attach using the eight hex screws,
removed in step
1 , and tighten using a hex
wrench (tightening torque of 1.4 N·m).
4
Attach the imager block adapter
receiver to the camera body adapter.
Align with the index marks on the top and
sides of the receiver, and attach using the two
hex screws, and tighten using a hex wrench
(tightening torque of 1.4 N·m).
2
1
Short
Index
mark
Index mark