Inicio rápido - configuración de sistema simple, English fr anç ais deut sche esp añol it aliano, 79 sistema inalámbrico concert 88 – Samson Concert 88 Camera Combo UHF Camera Wireless System (D: 542 to 566 MHz) User Manual
Page 79
79
Sistema Inalámbrico Concert 88
ENGLISH
FR
ANÇ
AIS
DEUT
SCHE
ESP
AÑOL
IT
ALIANO
Encienda su amplificador o mezclador conectado,
pero mantenga el volumen en el nivel mínimo. Gire
el mando de Volumen del CR88 totalmente en el
sentido contrario a las agujas del reloj (hasta su
posición “10”). Ésta es la ganancia unitaria.
Hable o cante al micrófono o, si está utilizando el transmisor con un instrumento
conectado, toque el instrumento con una intensidad del sonido normal. Suba lenta-
mente el volumen de su amplificador o mezclador hasta alcanzar el nivel deseado.
Si observa que el sistema sufre interrupciones evidentes, su rango operativo es menor
del que debiera o se producen estallidos sonoros imprevistos, cambie el canal opera-
tivo del sistema siguiendo los pasos indicados anteriormente.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
FREQ:
542-566MHz
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
FREQ:
542-566MHz
3. Plug in receiver
4. Turn on receiver
5. Plug receiver into audio system
6. Press Select button to change channel
9. Press and hold SELECT button to IR set
10. Adjust Volume control
7. Install batteries
8. Press button on transmitter to turn on
9. Press and hold Select button to IR set
7. Install batteries
8. Turn on belt pack transmitter
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
FREQ:
542-566MHz
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
FREQ:
542-566MHz
3. Plug in receiver
4. Turn on receiver
5. Plug receiver into audio system
6. Press Select button to change channel
9. Press and hold SELECT button to IR set
10. Adjust Volume control
7. Install batteries
8. Press button on transmitter to turn on
9. Press and hold Select button to IR set
7. Install batteries
8. Turn on belt pack transmitter
Inicio Rápido - Configuración de Sistema Simple
Una vez finalizada la transmisión, el CR88 recibirá
la señal de RF y la clave de tono del transmisor. El
indicador READY se iluminará en el panel frontal del
receptor CR88.