Samson Expedition XP106 Portable PA System with Wired Handheld Mic & Bluetooth - Manual (Page 11)

11 XP106 • Portable PA System
Follow these steps below to
quickly get started using your
XP106 portable sound system.
• Set the XP106's power
switch to the OFF
position, and fully turn
all of the
LEVEL controls
counterclockwise to 0.
• If an outlet is available,
connect the included power
adaptor to the
DC IN of the
speaker, and plug it into an
AC socket.
• Connect a microphone
using a standard XLR cable,
line level equipment using
a
1 ⁄
4
" instrument cable, or
portable audio device using
a
1 ⁄
8
" cable.
• Switch on the XP106
power.
• While speaking into the microphone or playing music from a line level
audio source, slowly raise the channel LEVEL until you have reached the
desired level.
NOTE: If not using the channel 1 input, turn the LEVEL control all the way down to
keep out any unwanted noise.
Quick Start
Setting a Good Level
Use the Channel LEVEL controls to set the individual volume of your micro-
phone, line level and
Bluetooth ® devices.
The PEAK light illuminates when the signal sending to the internal amplifier
begins to reach a level where distortion occurs. If the PEAK lights stay on,
your mix is too hot and you need to lower the LEVEL controls. It is okay for the
PEAK light to occasionally light, however it should go off quickly and should
not constantly stay on.
ENGLISH
FRANÇAIS
DEUTSCHE
ESP
AÑOL
IT
ALIANO