Screen adjustment, Calibration report, Pbp mode – Samsung C49RG9 49" 32:9 120 Hz Curved FreeSync HDR VA Gaming Monitor User Manual
Page 37: Screen adjustment 37, Calibration report 37, Pbp 37, Pbp mode 37, 37 screen adjustment
37
Screen Adjustment
―
This option is only available when
PC/AV Mode
is set to
AV
.
―
This menu is only available when
Screen Size
is set to
Screen Fit
in
AV
Mode.
When a 480P or 576P or 720P or 1080P signal is input in
AV
mode and the monitor can display normally, select
Screen Fit
to adjust horizontal position in 0-6 levels.
―
This menu is not available when
PBP
is enabled.
Configuring H-Position & V-Position
H-Position
: Move the screen to the left or right.
V-Position
: Move the screen up or down.
Calibration Report
The data from this report are measured in
Custom
mode at the time of shipment.
•
The measurements may vary according to the measuring equipment, measuring location, system
environment (e.g. computer, graphic board, etc) and other variables.
•
Input signal:
HDMI
•
Each measurement from this report is based on the
Custom
mode at the time of shipment.
•
This report is not provided on the menu of some products, but in an separate hardcopy report
instead.
PBP
Configuring the PBP Settings.
PBP Mode
Enable or disable the
PBP Mode
function.
The PBP (Picture by Picture) function separates the screen into two parts displaying output from two
different sources simultaneously on the left and right sides of the screen.
―
PBP
mode is compatible with Windows 7, Windows 8, and Windows 10.
―
Make sure that the graphics card supports the PBP function. Visit the website of the graphics card
manufacturer to check and update its driver to the latest version.
―
The screen may flicker briefly or appear after a delay when you enable or disable the
PBP
function or when
you change the screen size with the
PBP
function activated.
This can typically arise when a PC and a monitor are connected to two or more input sources. It has nothing to
do with the performance of a monitor.
The issue is mainly caused when the video signals are delayed in transmission to the monitor depending on
the graphics card performance.
―
When the
PBP
function is enabled, the resolution will not be able to automatically switch to the optimum
resolution due to a compatibility issue between the graphics card and the Windows system.
Set
PBP Mode
to
Off
. Alternatively, restart the monitor, then set the resolution to the optimum setting using
the Windows interface.