Pc/av mode 34, Displayport ver. 34, Hdmi mode 34 – Samsung ViewFinity UR59C 32" 4K Curved Monitor User Manual
Page 34: Source detection 34, Key repeat time 34, 34 pc/av mode, Displayport ver, Hdmi mode, Source detection, Key repeat time
34
PC/AV Mode
Set
PC/AV Mode
to
AV
. The picture size will be enlarged.
This option is useful when you view a movie.
•
Set to
PC
when connected to a PC.
•
Set to
AV
when connected to an AV device.
―
Supplied for the wide models only such as 16:9 or 16:10.
―
If the monitor (when set to
HDMI
,
DisplayPort
) is in power saving mode or is displaying the message
Check
Signal Cable
, press the
icon to display the On Screen Display (OSD). You can select
PC
or
AV
.
DisplayPort Ver.
Select your Displayport.
―
Incorrect settings may cause the screen to go blank. If this occurs, check the device specifications.
―
If the monitor (when set to
HDMI
,
DisplayPort
) is in power saving mode or is displaying the message
Check
Signal Cable
, press the
icon to display the On Screen Display (OSD). You can select
1.1
or
1.2↑
.
―
If you select
1.1
, the maximum resolution of your screen drops to 2560 x 1440 due to the limitations in HBR1
transmission speeds.
HDMI Mode
Select the HDMI mode to use.
―
The supportable device and resolution may differ depending on its version.
―
When the version is changed, the screen may blink.
―
If you set the
HDMI Mode
to
1.4
, some high resolutions may not be supported because of bandwidth
limitation of the HDMI 1.4 protocol.
―
When the setting is not appropriate, a blank screen may appear. In this case, check the specifications of the
device.
―
Set the
HDMI Mode
to
1.4
when there is no sound output from the DVD connected to our product.
―
Not available when
PBP Mode
is set to
On
.
―
If the monitor(when set to
HDMI
) is in power saving mode or is displaying the message
Check Signal Cable
,
press the
icon to display the On Screen Display(OSD). You can select
1.4
or
2.0
.
Source Detection
Select either
Auto
or
Manual
as the method to recognize input signal.
―
Not available when
PBP Mode
is set to
On
.
Key Repeat Time
Control the response rate of a button when the button is pressed.
Acceleration
,
1 sec
, or
2 sec
can be selected. If
No Repeat
is selected, a command responds only once
when a button is pressed.