Samsung ViewFinity S8 32" 4K HDR Monitor - Manual (Page 33)

33
2nd 3rd Description
Auto Source Switch+ Auto Source Switch+ When there is no signal, the display automatically switches to the newly connected device.
―
This function may not be supported depending on the model or geographical area.
USB-C Switch When there is no signal, the display automatically switches to the new device connected to the USB-C port.
Key Repeat Time Control the response rate of a button when the button is pressed.
Acceleration , 1 sec or 2 sec can be selected. If No Repeat is selected, a command responds only once when a button is pressed.
Power LED On Configure the settings to enable or disable the power LED located at the lower part of the product.
• Working : The power LED is on when the product is turned on.
• Stand-by : The power LED is on when the product is turned off.
USB-C Preference Choose between high resolution and data transfer speed. If you change the settings during data transfer, the transfer may be canceled or data
corruption may occur.
• High Resolution : If High Resolution is selected, 3840 x 2160 @ 60 Hz is available for input of USB-C. The performance for ports may be
limited. The port operates as USB 2.0.
• High-Speed Data : If High-Speed Data is selected, 3840 x 2160 @ 60 Hz is not available for input of USB-C. The port operates as USB 3.0.
Setup Custom Key Set the custom key so that your chosen function can be set up directly.
Eco Sensor Mode Optimizes brightness in real time, based on your lighting environment.
Max. Power Saving Set to on, Ethernet is turned off to save power. Set to off, the USB-C connected PC or laptop can be woken by LAN.